A fax machine can be used with Shaw Digital Phone, allowing you to send and receive fax messages. On this page you will find information relating to setting up your fax machine with Shaw Digital Phone, and some solutions to issues that you may encounter.
On This Page
It is recommended that you use a distinctive ring or a dedicated secondary line if you would like to use a fax machine in your household. A distinctive ring line will exist along with your main telephone line, but will have its own phone number, and can be set to ring in a distinctive pattern that your fax machine will recognise. This allows the machine to differentiate between voice calls for your phone and faxes that should go to the fax machine. Alternatively, a secondary line is a separate phone line that is connected directly to the fax machine, and which relies on its own distinct phone number. This can be important for customers that use their fax machine frequently as a Secondary Line will remain available when your primary home phone line is in use.
- Set up your Distinctive Ring/Secondary Line with a Shaw representative
- Connect a telephone cable from one of your available phone jacks on the wall to the port on the fax machine labelled "in" or "input"
- If your fax machine has a telephone connected to it you can check to see if you have a dial tone
- If you are using a Distinctive Ring/Secondary Line you must set the fax machine to recognize the distinctive ring pattern. The most common pattern is two short rings
1. Check the physical line:
Ensure the line from the wall jack is plugged into the right port on the back of the fax machine. Most fax machines have 2 ports; 1 is for the line and the other is for external handset. If you have a HP machine, you must use the HP supplied cord as this is proprietary of the machine as other telephone wires will not work
2. Check the answering mode on the machine:
The answering mode should be set on manual. If you are experiencing challenges, visit the fax machine manufacturer’s website and find the manual for assistance with the necessary steps.
3. Check the number of rings that fax is set to answer:
Please ensure that the number of rings is set lower than voicemail. Two or three rings will usually work.
4. Check Distinctive Ring Pattern:
If you are using a distinctive ring or a secondary line, please ensure that your fax has been set to recognize the pattern of that distinctive ring. The two short rings pattern will typically be used by default.
5. Check the baud rate (Advanced):
This issue lies with faxing software, as most fax machines do not have a setting to adjust the baud rate. This should be set to 14400 or 9600 kbp/s.
Still Need A Little Help?
See what other customers are asking, or sign-in to ask
your own question, in the Phone forum.