Learn more about the Shaw Champion remote control including how to program and set the volume controls with these tips. The Champion is the universal version of the Champ remote that is currently provided with both Standard Definition and non-PVR High Definition cable boxes.

Additional information can be found from the related Articles section near the end of this document.

Programming your Shaw Champion remote

There are two different ways to program your Shaw Champion remote control. You can program the remote to control all of the devices in your home theatre with one easy-to-use remote control. 148627_shaw-champion-remote-control

Method 1:
To program your Champion Remote control, you will first need to turn on the television. Once powered on, proceed with the following directions:

  1. Press and hold SETUP until mode key blinks twice 
  2. Press the mode key for the device you wish to setup. The mode key will stay lit. 
  3. Press and hold the OK key
  4. Keep holding down the key until the device turns off

 

Method 2:
To program your Champion Remote control, you will first need to turn on the device you would like to program with the remote (for example your television, audio system Blu-Ray or DVD player). Once powered on, proceed with the following directions:

  1. Press and hold SETUP until mode key blinks twice
  2. Press the mode key for the device you wish to setup. The mode key will stay lit
  3. Find your device and brand from the chart below and note the DIGIT key assigned to your brand. Press and hold down the DIGIT key for your device/brand
  4. Let go of the key when your device turns off

148638_shaw-champion-remote-top

 

Digit Television DVD/VCR Audio
1 Insignia/Dynex Insignia/Dynex Bose
2 LG/Zenith LG Denon
3 Mitsubishi Panasonic LG
4 Panasonic Philips/Magnavox Onkyo
5 Magnavox RCA Panasonic
6 Samsung Samsung Philips
7 Sharp Sharp Pioneer
8 Sony Sony Samsung
9 Toshiba Sylvania Sony
0 Vizio Toshiba Yamaha
Example: The Digit key for a Panasonic DVD/VCR is a 3.

Setting the Volume control

If you want the remote control to adjust volume with a stereo system instead of the television, proceed with the following directions:

  1. Press and hold SETUP until mode key blinks twice
  2. Press the volume + key
  3. Press the mode key that corresponds to the device you want to use for volume controls

Troubleshooting Tips

Follow these steps to replace your coaxial cable going into your digital box.

Mode key does not blink when a key is pressed.
The batteries may be dead. Try replacing both AA batteries.
 
Mode key blinks, but the remote does not control my equipment.
Press the correct mode key and point the remote at the equipment you need to control.
 
I tried all of the codes for my brand of device and none of them work.
Visit urc support and search for additional codes.

Labels (1)
Top
TALK TO US
We're here to help