My new remote won't cycle to turn off my pvr box & the tv unless I hit cbl and then I hit the tv button
Jronson, the feature you are looking for is called Master Power, where you press the power button once, and it first powers off the box and then powers off the TV. If you set up your remote for Master Power, sometimes this can cause issues, for example if someone should walk in front of the remote before it's finished it's cycle, or if you drop your hand down too quickly, you will have to either get up to power on the TV, or grab the original TV remote, to get the two devices back into sync again. That said, here are the steps to programming the remote for Master Power.
Set your TV to match what your cable terminal currently is - both devices either on or off.
Press and Hold Setup until device light flashes Twice,
Enter 9-9-5 that device light should flash twice again
Press Power Once
Press Cable then Power
Press TV then Power
Press Cable then press and Hold Setup until Cable flashes twice.
This should re-program the Master Power feature.
That worked perfectly. Many thanks.
Retrieving data ...