I'm having trouble programming my remote control to my receiver so it doesn't interfere with my other receiver's. I found my remote on the website and followed the directions but couldn't enter a new address.
Try changing the batteries? - Shot in the dark
If the remote still controls the receiver after, I would suspect that the remote isn't changing channels.
Otherwise have to wait for one of the Shaw Direct moderators
To confirm, you are using Shaw Direct?
Which remote model? Which receiver model?
Receiver is HDPVR630 remote is IR/RF 600
Hello, do you have any instructions so I can program my remote to the receiver?
donovon is our Shaw Direct moderator. He should be able to offer some assistance here when available.
The instructions that I have
Press the SAT button to select the remote control's SAT mode.
Press the OPTIONS button to display the Options screen on your TV.
Remote Control Address
Leave the DSR630 on this screen
Now on your remote,
Press and hold the SAT mode key until the red lights flash at least twice and release the SAT key
Enter a new 3 Digit SAT address, so press 006 on the remote
Press ENTER/OK to save the new address and pair the remote with your satellite receiver.
You should be able to press Exit to exit back to TV, and this should have your remote and receiver on a new address
I've done all of that, the address numbers don't change, they don't even blink or otherwise indicate any connection.
Changing the batteries worked, thank you.
Retrieving data ...