I just purchased a hard drive and case which I have assembled and am ready to add to my Arris GATEWAY system.
Western Digital Green 2TB SATA3 6GB/S Intellipower 64MB Cache 3.5in Internal Hard Drive HDD
Vantec Nexstar CX 3.5in SATA to USB 2.0 and eSATA External Hard Drive Enclosure
The only info I have stumbled across says:
1. Connect cable from the drive to the eSATa port on HDPVR 630??
2. Switch on the external hard drive.
3. RESTART your HDPVR 630 by holding down the power button on the front panel for ten seconds
(The info made no mention of turning off the PVR at the start)
4. When the receiver comes back on a setup wizard will guide you.
This information seems to be inadequate for the Arris system. Suggestions or a link to the info?