Passthru to a Cisco RVS4000 router but speed is very slow on a 150 service.
When you plug a direct ethernet from your computer into that port and bypassing your router, do you get the proper speeds?
Also, are you running a VPN with the Cisco RVS4000 router?
Tony | Community Mod.
Full speed when bypassing the router & not running VPN.
I have the passthru running from #4 port to the WAN input on the RVS4000 and RVS4000 set as Gateway.
Is this correct?
You should be setting the Passthrough to the MAC address of the RVS4000. I have steps here if you need some more instructions.
I'll try that and see.
No, didn't fix.
Sometimes the simple steps are the best. Could you do a pinhole reset on both the wifi modem and the router and then test again? You might need to go back to the router to reset router name and such in case the router puts everything back to default.
Didn't work. Will play with it some more and see. In the end, I'll will get the modem bridged.
Sounds good madmax49! Keep us in the loop if we can help with anything.
Retrieving data ...