I have replaced my Onkyo AV receiver with a Sony STR-DN1080. I have reprogrammed the Bluesky remote to turn the new AV Receiver on an off and to control the audio volume. But when I turn on the AV Receiver I need the remote to also select the correct HDMI input. Right now it uses whatever input was selected when the AV Receiver was last turned off. If it was not the Shaw box I have to use the Sony remote to change the input, which is annoying, since this is the only reason to use the Sony remote during everyday use.
Can the Bluesky remote be programmed to select a specific input when it turns on the AV receiver? It worked fine with the Onkyo AV receiver. In that case, the Shaw technician programmed the remote when he set up Bluesky. I wish I had taken notes!