New TV programming remote will only switch the input on the TV to TV (instead of the HDMI input) and not turn the TV on or off. What am I doing incorrectly?
Probably need to try different programming codes, if there are more available for the brand.
Tried all the codes, tried the quick remote setup on the back of the remote, and will not get to TV power off will only switch the input to TV, have tried to continue on with the channel up and have pressed more than 400times, it doesn't work
Did you check the website for codes? Or just the book?
The website would be http://www.urcsupport.com/shaw (select your remote and you'll see a code search option where you can input your brand of TV). See if any of those codes work for you. If you've tried them all though and even tried a code search (steps will be there to search all possible codes), unfortunately the remote may not have a code for your make and model.
Hope this helps.
Just upgraded the remote at shaw, is there a different one I need?
So you got a new remote pengor? Try the codes for your TV on the website I listed above after selecting your new remote model. Hopefully one of them works for you now.
Retrieving data ...