I'm trying to setup an e4200v2 as an Access Point in my house. On initial setup, everything works for about 10 minutes, but then the e4200 stops having internet connection. When I power cycle the e4200, it makes no difference. When I power cycle the Cisco, it makes no difference. I have to reset the Cisco to get it working again, but then it only works for a few minutes and then again stops passing through the internet to the e4200. I still have access to the LAN via wifi, just no internet connectivity. I'm not sure why.
Cisco LAN --> e4200 WAN (in bridge mode)
The Cisco is all default settings.
Specific IP address - 192.168.0.2
Manual - G-Band is on 20Mhz Ch 11
- N Band is on 20 or 40 Mhz, auto Channel
Any ideas as to why it works for a bit and then just stops working?? I don't get it...