When I'm using the PVR to watch recorded programs it will not start at the same spot I paused or rewound back to like my previous 6416 model did.
Is there a fault with the DCX 3400 or is this an operator error? Thank you.
I can push Last to exit, or Stop to stop and then Exit to go back to live TV with my DCX3400, when I push Play again, it continues where I stopped it.
Make sure after selecting it in your PVR list, that you just choose Play and not Play From Beginning.
Thanks kevinds for your reply. I probably didn't explain my question properly. I understand what you are saying and use that procedure. But when I'm already watching a recorded program and I press pause, then rewind, then pause and then play, it won't start where I last paused it at. It will start either about 10 seconds before or after where I last paused after I rewound it to so I can review a certain piece of the recording again. I hope I explained it better this time, thank you.
The behavior you're describing sounds normal, but it can be avoided. If you pause first, and then rewind, pressing pause again will bring you back to the point you originally paused at, unless you rewind for a greater length of time (1 or 2 minutes I believe). You may find that it works better if you just press rewind to begin with, rather than pausing first.
Yeah, that is normal.
It's almost like it takes a second to react when you press a button on the remote, when fast forwarding, it takes an extra second to stop, so it jumps back to when you actually press the button.
Same thing when pausing, it is just 'stopped' on a different frame. I noticed the faster you are rewinding/fast-forwarding the more it jumps
Retrieving data ...